4
White Electronic Designs Corporation • (602) 437-1520 • www.whiteedc.com
WS512K32V-XXX
AC TEST CIRCUIT
NOTES:
VZ is programmable from -2V to +7V.
IOL & IOH programmable from 0 to 16mA.
Tester Impedance Z0 = 75 Ω.
VZ is typically the midpoint of VOH and VOL.
IOL & IOH are adjusted to simulate a typical resistive load circuit.
ATE tester includes jig capacitance.
I
Current Source
D.U.T.
C = 50 pf
eff
I
OL
V
≈
1.5V
(Bipolar Supply)
Z
Current Source
OH
AC TEST CONDITIONS
Parameter Typ Unit
Input Pulse Levels VIL = 0, VIH = 2.5 V
Input Rise and Fall 5 ns
Input and Output Reference Level 1.5 V
Output Timing Reference Level 1.5 V
AC CHARACTERISTICS
(VCC = 3.3V, TA = -55°C to +125°C)
Parameter Symbol -15 -17 -20 Units
Read Cycle Min Max Min Max Min Max
Read Cycle Time tRC 15 17 20 ns
Address Access Time tAA 15 17 20 ns
Output Hold from Address Change tOH 000ns
Chip Select Access Time tACS 15 17 20 ns
Output Enable to Output Valid tOE 8810ns
Chip Select to Output in Low Z tCLZ1111ns
Output Enable to Output in Low Z tOLZ1000ns
Chip Disable to Output in High Z tCHZ18810ns
Output Disable to Output in High Z tOHZ18810ns
1. This parameter is guaranteed by design but not tested.
AC CHARACTERISTICS
(VCC = 3.3V, TA = -55°C to +125°C)
Parameter Symbol -15 -17 -20 Units
Write Cycle Min Max Min Max Min Max
Write Cycle Time tWC 15 17 20 ns
Chip Select to End of Write tCW 12 12 14 ns
Address Valid to End of Write tAW 12 12 14 ns
Data Valid to End of Write tDW 9910ns
Write Pulse Width t WP 12 14 14 ns
Address Setup Time tAS 000ns
Address Hold Time tAH 000ns
Output Active from End of Write tOW1233ns
Write Enable to Output in High Z tWHZ1889ns
Data Hold Time tDH 000ns
1. This parameter is guaranteed by design but not tested.