Revised April 2003 NC7WB3125 TinyLogic UHS 2-Bit Low Power Bus Switch General Description Features The NC7WB3125 is a 2-bit ultra high-speed CMOS FET bus switch with TTL-compatible active LOW control inputs. The low On Resistance of the switch allows inputs to be connected to outputs with minimal propagation delay and without generating additional ground bounce noise. The device is organized as a 2-bit switch with independent bus enable (OE) controls. When OE is LOW, the switch is ON and Port A is connected to Port B. When OE is HIGH, the switch is OPEN and a high-impedance state exists between the two ports. Control inputs tolerate voltages up to 5.5V independent of VCC. Space saving US8 surface mount package MicroPak leadless package Typical 3 switch resistance at 5.0V VCC Minimal propagation delay through the switch Power down high impedance input/output Zero bounce in flow through mode TTL compatible active LOW control inputs Control inputs are overvoltage tolerant Bus switch replacement for Logic x125 part Ordering Code: Product Order Number Package Code Package Description Supplied As Number Top Mark NC7WB3125K8X MAB08A WB25 NC7WB3125L8X MAC08A (Preliminary) T4 8-Lead US8, JEDEC MO-187, Variation CA 3.1mm Wide 3k Units on Tape and Reel 8-Lead MicroPak, 1.6 mm Wide 5k Units on Tape and Reel TinyLogic is a registered trademark of Fairchild Semiconductor Corporation. MircoPak is a trademark of Fairchild Semiconductor Corporation. (c) 2003 Fairchild Semiconductor Corporation DS500376 www.fairchildsemi.com NC7WB3125 TinyLogic UHS 2-Bit Low Power Bus Switch May 2000 NC7WB3125 Connection Diagrams Logic Diagram (Top View) Pin One Orientation Diagram Pin Descriptions Pin Name Description A Bus A B Bus B OE Bus Enable Input AAA represents Product Code Top Mark - see ordering code Note: Orientation of Top Mark determines Pin One location. Read the top product code mark left to right, Pin One is the lower left pin (see diagram). Function Table Pad Assignments for MicroPak Bus Enable Input OE Function L B Connected to A H Disconnected (Top Thru View) www.fairchildsemi.com 2 Recommended Operating Conditions (Note 3) Supply Voltage (VCC) -0.5V to +7.0V DC Switch Voltage (VS) -0.5V to +7.0V Supply Operating (VCC) DC Output Voltage (VIN) (Note 2) -0.5V to +7.0V Control Input Voltage (VIN) 0V to 5.5V Switch Input Voltage (VIN) 0V to 5.5V DC Input Diode Current (IIK) VIN < 0V DC Output (IOUT) Current -50 mA Output Voltage (VOUT) 128 mA Operating Temperature (TA) DC VCC or Ground Current 0V to 5.5V -40C to +85C Input Rise and Fall Time (tr, tf) 100 mA (ICC/IGND ) Storage Temperature Range (TSTG) 4.0V to 5.5V Switch Control Input -65C to +150C +150C Junction Temperature under Bias (TJ) 0 ns/V to 5 ns Switch I/O 0 ns/V to DC Thermal Resistance (JA) 250C/W Junction Lead Temperature (TL) +260C (Soldering, 10 Seconds) Power Dissipation (PD) @ +85C 250 mW Note 1: The "Absolute Maximum Ratings" are those values beyond which the safety of the device cannot be guaranteed. The device should not be operated at these limits. The parametric values defined in the Electrical Characteristics tables are not guaranteed at the absolute maximum ratings. The "Recommended Operating Conditions" table will define the conditions for actual device operation. Note 2: The input and output negative voltage ratings may be exceeded if the input and output diode current ratings are observed. Note 3: Unused logic inputs must be held HIGH or LOW. They may not float. DC Electrical Characteristics Symbol Parameter (V) VIK Clamp Diode Voltage VIH HIGH Level Input Voltage 4.0 to 5.5 VIL LOW Level Input Voltage 4.0 to 5.5 VOH HIGH Level Output Voltage 4.0 to 5.5 IIN Input Leakage Current IOFF RON ICC TA = -40C to +85C VCC Min Typ Max -1.2 4.5 2.0 Units V Conditions IIN = -18 mA V 0.8 V V VIN = VCC 5.5 1.0 A 0 VIN 5.5V Switch OFF Leakage Current 5.5 1.0 A 0 A, B VCC Switch On Resistance 4.5 3 7 (Note 4) 4.5 3 7 4.5 6 15 4.0 10 20 Quiescent Supply Current See Figure 3 5.5 3 VIN = 0V, IIN = 64 mA VIN = 0V, IIN = 30 mA VIN = 2.4V, IIN = 15 mA VIN = 2.4V, IIN = 15 mA A VIN = VCC or GND IOUT = 0 ICC Increase in ICC per Input (Note 5) 5.5 1 2.5 mA VIN = 3.4V, One OE Input only, Other OE = VCC Note 4: Measured by the voltage drop between A and B pins at the indicated current through the switch. On Resistance is determined by the lower of the voltages on the two (A or B) pins. Note 5: Per TTL driven input (VIN = 3.4V, control input only). A and B pins do not contribute to ICC. 3 www.fairchildsemi.com NC7WB3125 Absolute Maximum Ratings(Note 1) NC7WB3125 AC Electrical Characteristics TA = -40C to +85C, Symbol Parameter tPHL, Propagation Delay Bus to Bus tPLH (Note 6) tPZL, Output Enable Time Output Disable Time CL = 50 pF, RU = RD = 500 (V) Min Typ 4.0 to 5.5 0.25 0.8 2.5 4.2 4.0 0.8 3.0 4.6 4.5 to 5.5 0.8 3.1 4.8 4.0 0.8 2.9 4.4 tPHZ Units Conditions Max 4.5 to 5.5 tPZH tPLZ, VCC Figure Number ns ns ns VI = OPEN Figures 1, 2 VI = 7V for tPZL Figures 1, 2 VI = 0V for tPZH VI = 7V for tPLZ Figures 1, 2 VI = 0V for tPHZ Note 6: This parameter is guaranteed by design. The bus switch contributes no propagation delay other than the RC delay of the typical On Resistance of the switch and the 50 pF load capacitance, when driven by an ideal voltage source (zero output impedance). The specified limit is calculated on this basis. Capacitance Symbol Parameter Typ Max 2.5 Units pF Conditions VCC = 0V CIN Control Pin Input Capacitance CI/O (OFF) Port Off Capacitance 6 pF VCC = 5.0V = OE CI/O (ON) Switch ON Capacitance 12 pF VCC = 5.0V, OE = 0V AC Loading and Waveforms Input driven by 50 source terminated in 50 CL includes load and stray capacitance Input PRR = 1.0 MHz; tW = 500 ns FIGURE 1. AC Test Circuit FIGURE 2. AC Waveforms www.fairchildsemi.com 4 NC7WB3125 DC Characteristics FIGURE 3. Typical High Level Output Voltage vs. Supply Voltage 5 www.fairchildsemi.com NC7WB3125 Tape and Reel Specification TAPE FORMAT for US8 Package Tape Number Cavity Section Cavities Status Status Leader (Start End) 125 (typ) Empty Sealed Designator K8X Cover Tape Carrier 250 Filled Sealed Trailer (Hub End) 75 (typ) Empty Sealed Cover Tape TAPE DIMENSIONS inches (millimeters) TAPE FORMAT for MicroPak Package Designator L8X Tape Number Cavity Section Cavities Status Status Leader (Start End) 125 (typ) Empty Sealed Carrier 250 Filled Sealed Trailer (Hub End) 75 (typ) Empty Sealed TAPE DIMENSIONS inches (millimeters) www.fairchildsemi.com 6 NC7WB3125 Tape and Reel Specification (Continued) REEL DIMENSIONS inches (millimeters) Tape Size 8 mm A B C D N W1 W2 W3 7.0 0.059 0.512 0.795 2.165 0.331 + 0.059/-0.000 0.567 W1 + 0.078/-0.039 (177.8) (1.50) (13.00) (20.20) (55.00) (8.40 + 1.50/-0.00) (14.40) (W1 + 2.00/-1.00) 7 www.fairchildsemi.com NC7WB3125 Physical Dimensions inches (millimeters) unless otherwise noted 8-Lead US8, JEDEC MO-187, Variation CA 3.1mm Wide Package Number MAB08A www.fairchildsemi.com 8 NC7WB3125 TinyLogic UHS 2-Bit Low Power Bus Switch Physical Dimensions inches (millimeters) unless otherwise noted (Continued) 8-Lead MicroPak, 1.6 mm Wide Package Number MAC08A (Preliminary) Fairchild does not assume any responsibility for use of any circuitry described, no circuit patent licenses are implied and Fairchild reserves the right at any time without notice to change said circuitry and specifications. LIFE SUPPORT POLICY FAIRCHILD'S PRODUCTS ARE NOT AUTHORIZED FOR USE AS CRITICAL COMPONENTS IN LIFE SUPPORT DEVICES OR SYSTEMS WITHOUT THE EXPRESS WRITTEN APPROVAL OF THE PRESIDENT OF FAIRCHILD SEMICONDUCTOR CORPORATION. As used herein: 2. A critical component in any component of a life support device or system whose failure to perform can be reasonably expected to cause the failure of the life support device or system, or to affect its safety or effectiveness. 1. Life support devices or systems are devices or systems which, (a) are intended for surgical implant into the body, or (b) support or sustain life, and (c) whose failure to perform when properly used in accordance with instructions for use provided in the labeling, can be reasonably expected to result in a significant injury to the user. www.fairchildsemi.com 9 www.fairchildsemi.com