Digital Tilt Sensor SKU:DFR0028 Contents 1 Introduction 2 Specification 3 Connection Diagram o 3.1 Sample Code Introduction The DFRobot Tilt Sensor is a digital tilt switch. It could be used as a simple tilt sensor. Simple plug to our IO/Sensor Expansion board, you can make amazing interactive projects. The dedicated sensor expansion boards with the Arduino, in combination, can achieve very interesting and an interactive work. Specification Supply Voltage: 3.3V to 5V Interface: Digital Size:22x30mm Connection Diagram Sample Code int ledPin = 13; // Connect LED to pin 13 int switcher = 3; // Connect Tilt sensor to Pin3 void setup() { pinMode(ledPin, OUTPUT); // Set digital pin 13 to output mode pinMode(switcher, INPUT); // Set digital pin 3 to input mode } void loop() { if (digitalRead(switcher) == HIGH) //Read sensor value digitalWrite(ledPin, HIGH); // Turn on LED when the sensor is tilted else digitalWrite(ledPin, LOW); gered // Turn off LED when the sensor is not trig } Powered By DFRobot (c) 2008-2017