! $ % &' .6 !" " # 4 6'0 >? : 6799/. " ; $< NOTE: # $ Figure 2 ),*/ i ),*/ = :3# % &!' i < " " ,2 Figure 1 : 4 9< 1. Lay conductors between connector blocks, aligning cable jacket with rear of jack assembly. " ()*+,- *(,) 2. Lace brown pair and opposite rear color pair with appropriate color code slots (use minimum slack while maintaining twist to within 12.7 mm [.50 in.] of termination). This instruction sheet provides termination procedures for the unshielded 110Connect panel mount jacks (Category 3 and 5e) with universal wiring label. ),*/ ),*/ i i 1 *(,) ! Reasons for reissue of this sheet are provided in Section 4, REVISION SUMMARY. 4. Repeat Steps 2 and 3 with blue pair and opposite front pair. The jacks accept four pair, twisted-pair cable with 22 to 26 AWG solid conductors and 20 to 26 AWG stranded conductors. The maximum conductor insulation diameter is 1.27 mm [.050 in.]. 5. The optional stuffer cap may be used for termination or it may be added for additional strain relief. " */+()1*(,) "." ,2 . 3 1 0 +4 E ! D ($ $ %&' " *"+ ' # ! $ +- ! !+ +" ./0/1/.... "23 +4"5! + ./0/6/716 $ $ ) $ % % 4 # %&' $ $ 4 9< 2. Pull brown pair and opposite rear color pair through opening on opposite sides. Bend wires around blocks and align them with appropriate color code slots (use minimum slack while maintaining twist). ! " " : 1. Bend conductors back to right angle to cable and insert cable between connector blocks. Strip back only as much cable jacket as necessary to perform termination. See Figure 2. i $ - $ 3 3. Use tool to punch wires down into slot and cut off excess wire. Remove loose wire pieces. ." -/0 +(*(,) ),*/ ( ) * + ,&-& %./#0D 12 ( * + # ) ' ) $ $ # % 8 $ " % ' # !!!" " # Option 1 Option 2 $# % $& " # %$ & "$ $& $' ' $ & $ ! $' $& " ' $ & "$ $& $# % # %$ ! " # $' $& $# % & $ ! " # $& " & "$ ' $ " & ' $ & $ $' & $ ! " # $& " & "$ $# % # %$ $& # %$ " # ( & " & ( & Figure 3 $#' i %'!#$ ! ! "#$%& '( ! ) * ) * + , - - - - ) 3. Use tool to punch wires down into slot and cut off excess wire. Remove loose wire pieces. 4. Repeat Steps 2 and 3 with blue pair and opposite front pair. 5. Press conductors flat against blocks. !"!#$ "%& Since the last revision to this document, the following changes were made: S Updated document to corporate requirements.