Electrical Characteristics: (VCC = 5V, VEE = Gnd, TA = +25°C unless otherwise specified)
Parameter Symbol Test Conditions Min Typ Max Unit
Input Offset Voltage VIO VCC = 5V to 30V, –2.0 7.0 mV
VIC =0 to VCC–1.7V,
VO ] 1.4V, RS = 0Ω0° ≤ TA ≤ +70°C– – 9.0 mV
Average Temperature Coefficient
of Input Offset Voltage ∆VIO/∆T 0° ≤ TA ≤ +70°C–7.0 –µV/°C
Input Offset Current IIO –5.0 50 nA
0° ≤ TA ≤ +70°C– – 150 nA
Average Temperature Coefficient
of Input Offset Current ∆IIO/∆T 0° ≤ TA ≤ +70°C–10 –pA/°C
Input Bias Current IIB – –45 –250 nA
0° ≤ TA ≤ +70°C– –50 –500 nA
Input Common–Mode Voltage VICR VCC = 30V, Note 4 0–28.3 V
Range 0° ≤ TA ≤ +70°C 0 –28 V
Differential Input Voltage Range VIDR – – VCC V
Large Signal Open–Loop AVOL RL = 2kΩ, VCC = 15V, 25 100 –V/mV
Voltage Gain For Large VO Swing 0° ≤ TA ≤ +70°C 15 – – V/mV
Channel Separation 1kHz ≤ f ≤ 20kHz, Input Referenced – –120 –dB
Common–Mode Rejection Ratio CMRR RS ≤ 10kΩ65 70 –dB
Power Supply Rejection Ratio PSRR 65 100 –dB
Output Voltage Range VOR RL = 2kΩ0–3.3 V
Output Voltage – High Limit VOH VCC = 30V,
RL = 2kΩ26 – – V
0° ≤ TA ≤ +70°CRL = 10kΩ27 28 –V
Output Voltage – Low Limit VOL VCC = 5V, RL = 10kΩ, 0° ≤ TA ≤ +70°C–5 20 mV
Output Source Current IO+ VID = +1V, VCC = 15V 20 40 –mA
Output Sink Current IO–VID = –1V, VCC = 15V 10 20 –mA
VID = –1V, VO = 200mV 12 50 –µA
Output Short–Circuit to GND Ios Note 5 –40 60 mA
Power Supply Current ICC VO = 0, RL = ∞,
VCC = 30V –1.5 3.0 mA
0° ≤ TA ≤ +70°CVCC = 5V –0.7 1.2 mA
Note 4. The input common–mode voltage or either input signal voltage should not be allowed to go
negative by more than 0.3V. The upper end of the common–mode voltage range is
VCC–1.7V, but either or both inputs can goto +32V without damage.
Note 5. Short circuit from the output to VCC can cause excessive heating and eventual destruction.
Destructive dissipation can result from simultaneous shorts on all amplifiers.