Tyco/Electronics PolySwitch(R) SiBar Raychem Corporation 308 Constitution Drive Menlo Park, CA 94025 800-227-4856 FAX 800-227-4866 PRODUCT: TVB270SA DOCUMENT: 24305 PCN: 574139 REV LETTER: B REV DATE: AUGUST 16, 2001 PAGE NO.: 1 OF 2 Thyristor Surge Protectors Specification Status: RELEASED PHYSICAL DESCRIPTION A MIN B MAX MIN MAX C MIN MAX D* MIN MAX H J K P S MIN MAX MIN MAX MIN MAX REF MIN mm: 4.06 4.57 3.30 3.81 1.90 2.41 1.96 2.11 .051 in: .160 .180 .130 .150 .075 .095 .077 .083 .002 * D DIMENSION SHALL BE MEASURED WITHIN DIMENSION P .152 .006 0.15 .006 0.30 .012 0.76 .030 1.27 .050 0.51 .020 5.21 .205 Other Physical Characteristics Form Factor: Lead Material: Encapsulation Material: Solderability: Solder Heat Withstand: Solvent Resistance: Mechanical Shock: Tape and Reel packaging per EIA 481-1 SMB (Surface Mount DO-214 Package) Tin/lead finish Epoxy, meets UL94 V-0 requirements per MIL-STD-750, Method 2026 per MIL-STD-750, Method 2031 per MIL-STD-750, Method 1022 per MIL-STD-750, Method 2016 MAX 5.59 .220 Tyco/Electronics PolySwitch(R) SiBar Raychem Corporation 308 Constitution Drive Menlo Park, CA 94025 800-227-4856 FAX 800-227-4866 PRODUCT: TVB270SA Thyristor Surge Protectors DEVICE RATINGS @ 25 C (Both Polarities) Parameter Off-State Voltage, Maximum at ID = 5 A Non-Repetitive Peak Impulse Current Double exponential waveform (Notes 1 and 2) 10x1000 sec 10/560 sec 10/160 sec Critical Rate of Rise of On-State Current Maximum 2x10 sec waveform, VOC=2.5kV, ISC=500A peak Symbol VDM IPP1 IPP2 IPP3 di/dt DEVICE THERMAL RATINGS Storage Temperature Range Operating Temperature Range Blocking or conducting state Overload Junction Temperature Maximum; Conducting state only Note 1. Allow cooling before test second polarity Note 2. Measured under pulse conditions to reduce heating VOLTAGE-CURRENT CHARACTERISTIC Value 270 50 70 100 Units V A A A 150 A/s TSTG TA -65 to 150 -40 to 125 C C TJ +175 C ELECTRICAL CHARACTERISTICS Both polarities (TJ @ 25C unless otherwise noted) Characteristics Symbol Min Breakover Voltage (+25C) ---VBO dV/dt = 100V/sec, Isc=1.0A, VDC = 1000V Breakover Voltage (+25C) f=60Hz, ISC=1.0Arms, VOC = 1000Vrms, R=1.0 k, t = 0.5 cycle (Note 2) Breakover Voltage Temperature Coefficient Off-State Current (VD1= 50V) (VD2= VDM) On-State Voltage (IT=1A) PW 300 sec, Duty Cycle 2% (Note 2) Breakover Current Holding Current (Note 2) Critical Rate of Rise of Off-State Voltage (Linear waveform, VD = 0.8 X Rated VBO, TJ= +25C) Capacitance (f=1.0 Mhz, 50VDC bias, 1 Vrms) (f=1.0 Mhz, 2VDC bias, 15mVrms) DOCUMENT: 24305 PCN: 574139 REV LETTER: B REV DATE: AUGUST 16, 2001 PAGE NO.: 2 OF 2 Typ 310 Max 370 Units V VBO ---- 310 370 V dVBO/dTJ ID1 ID2 VT ------------- 0.08 ------------- ----2.0 5.0 5.0 %/C A A V IBO IH dv/dt ---175 2000 230 350 ---- ----------- mA mA V/s C1 C2 ------- 20 50 ---- pF pF